Inserting The Bobbin; Changing The Presser Foot; Threading The Upper Thread - Texi Fox 25 Manual De Usuario

2. Take out bobbin case holding the latch.
3. When installing the bobbin case, the pin on the case should fit into the gap of the shuttle race.
Be sure to disconnect the power supply before operating the machine.

INSERTING THE BOBBIN

Threading the bobbin case
1. Install the bobbin into bobbin case. Make sure the thread unwinds in the direction of arrow.
1.
Place bobbin into bobbin holder with the thread unwinding counter clockwise.
2. Pull the thread into the groove in the bobbin case slot.
2. Draw thread into notch.
3. Now pull the thread under the tension spring and into the delivery eye.
3.
Pull thread toward the left and along the inside of spring until it slips into notch
NOTE: Leave about 10cm (4 inches) of the thread hanging out of the bobbin case. When
being sure that thread does not slip out of notch. Pull thread out about 10 cm.
you pull the thread, the bobbin should spin clockwise.
Threading the bobbin case
1. Install the bobbin into bobbin case. Make sure the thread unwinds in the direction of arrow.
2. Pull the thread into the groove in the bobbin case slot.
3. Now pull the thread under the tension spring and into the delivery eye.
NOTE: Leave about 10cm (4 inches) of the thread hanging out of the bobbin case. When
you pull the thread, the bobbin should spin clockwise.

Changing the presser foot

1. Turn the hand wheel toward you to raise the needle to its highest position.
Raise the presser foot.
CHANGING THE PRESSER FOOT
2. Press the lever on the back of the presser foot holder. The presser foot will drop off.
3. Place the presser foot so the pin on the foot lies just under the groove of the holder.
The presser foot must be changed according to the sewing job or stitch you sew.
Lower the presser foot holder to lock the foot in place.
CAUTION: Turn OFF the power switch before you change the presser foot.
1
Changing the presser foot
•
Turn the handwheel toward you until the needle is at its highest position.
1. Turn the hand wheel toward you to raise the needle to its highest position.
•
Raise the presser foot (1).
Raise the presser foot.
•
Remove the presser foot by pushing the presser foot release lever toward you (2).
2. Press the lever on the back of the presser foot holder. The presser foot will drop off.
•
Place desired foot with its pin directly under the slot (3).
3. Place the presser foot so the pin on the foot lies just under the groove of the holder.
•
Lower the presser foot lifter and the presser foot will snap into place.
Lower the presser foot holder to lock the foot in place.
1
Attaching the seam guide(optional)
Attach the seam guide in the slot as illustrated. adjust according to
need for hems pleats etc.
6
Attaching the seam guide(optional)
Attach the seam guide in the slot as illustrated. adjust according to
need for hems pleats etc.

THREADING THE UPPER THREAD

1.
Raise take-up lever to its highest position by turning hand wheel toward you.
Raise presser foot.
6
2.
Place spool on spool pin as shown, with thread coming from the back of the
spool.
3.
Draw thread into thread guide (1).
4. Guide thread through tension disc (2) and pull it up.
Texi Fox 25
EN
Gap
69