Removing The Bobbin; Winding The Bobbin; Inserting The Bobbin - Texi Tutu MC 9900 Manual De Operación

TEXI Tutu operation manual
BOBBIN WINDING

REMOVING THE BOBBIN

1. Remove the slide cover by sliding the locker to right
and push down the left corner of slide cover.
2. Remove the bobbin from the machine.

WINDING THE BOBBIN

1. Pivot spool pin into highest horizontal spool pin position.
2. Pass a spool of thread on the spool pin. Secure to place a spool of thread on the pin.
3. Pass thread fread from spool through thread guides as shown.
4. Pull end of thread through hole in bobbin as shown.
5. Make sure the bobbin winder shaft is in left position. Place bobbin onto shaft with end of thread coming from
top of bobbin. Push bobbin winder shaft to right until it clicks. Hold onto end of thread.
6. Start machine. The thread that is held will snap or may be trimmed with a scissors. Bobbin will cease turning
when completely filled. Push shaft to left to remove bobbin.

INSERTING THE BOBBIN

1. Place bobbin into bobbin holder with the thread
unwinding counter clockwise.
3. Pull thread toward the left and along the inside of spring (B)
until it slips into notch (C) being sure that thread does not slip
out of notch (A).
2. Draw thread into notch (A).
4. Pull thread out about 10 inches
and replace the slide cover.
126