Start And End Of Seam; Useful Sewing Tips; Turning Corners - Texi Fox 25 Manual De Usuario

START AND END OF SEAM

CAUTION: While sewing, spacial care is required
around the needle area. As the machine
automatically feeds the fabric, do not pull nor push
Raise the presser foot and position the fabric next to a
fabric.
stitching guide line on the needle plate.
Lower the needle into the fabric.
Lower the presser foot and smooth the thread towards the
1. Turn the handwheel toward you until the needle
back. Depress the foot control.
is at its highest point.
Gently guide the fabric along the guide line letting the
2.
Place the fabric under the presser foot.
fabric feed by itself.
3. Lower the presser foot.
4.
Hold back threads when starting machine. Let
threads go after sewing a few stitches.
5.
Regulate the speed while sewing.
For fastening the ends of seams, press the reverse stitch
6. Stop machine when you reach end of seam.
button and sew several reverse stitches.
Raise the presser foot and remove the fabric, drawing the
7.
Raise the presser foot lifter.
KNOWING YOUR SEWING MACHINE
threads to back.
8. When you have reached the end of a seam, stop
sewing and turn the hand wheel toward you to
bring the needle to it's highest position. Raise the

Useful sewing tips

presser foot and pull the fabric out from under
the foot to the back of the machine. Cut the
Various ways to achieve better sewing results are described below.
threads on the thread cutter.
Refer to these tips when sewing.
The threads are cut the proper length for starting the next
1. Trial sewing
seam.
Use different stitch width and length for trial sewing. When you have finished, select the
best looking stitch width and length for correct sewing.
For the trial sewing, use a piece of fabric and thread that are the same as those used for
your project, and check the thread tension and stitch length and width. Since the results
differ depending on the type of stitching and the number of fabric layers sewn, perform the
trial sewing under the same conditions that will be used with your project.

TURNING CORNERS

1.
2. Changing the sewing direction Stop the machine when you reach a
Stop the machine and turn the hand wheel
corner
toward you to bring the needle down into the
2. Lower needle into the fabric
fabric. Raise the presser foot.
3.
Raise the presser foot.
Pivot the fabric around the needle to change
4. Use the needle as a pivot and turn
sewing direction as desired. Lower the
fabric.
presser foot and continue sewing.
5. Lower the presser foot and resume
sewing.
3. Sewing curves
1).Stop sewing, and then slightly change the sewing direction to sew around the curve.
2).When sewing along a curve while using a zigzag stitch, select a shorter length in order to
obtain a finer stitch.
4. Sewing thick fabrics
If the fabric does not fit under the presser foot
Raise the presser foot even higher to bring the presser foot to its highest position. Then feed
Texi Fox 25
EN
13
75