Needle Threader - Texi Fox 25 Manual De Usuario

KNOWING YOUR SEWING MACHINE

NEEDLE THREADER

Lower the presser foot. Set needle in up position.
Using automatic needle threader
1.
Lower the threader slowly and draw thread through guide and pull toward the
right.
Raise the needle to its highest position by rotating the hand wheel towards you.
2.
Lower the lever as far as will go.
1. Hook thread to thread guide as illustrated.
3. Rotate the lever to the rear of the machine and the hook pin will go through the
2. Pull down lever while holding the end of thread.
needle eye.
3. Rotate the lever to the rear of the machine.
4. 4. Guide thread into hooked end and pull the thread upward. Draw thread through the hooked end.
5. Return the lever and needle will be threaded automatically.
5.
Hold thread loosely and slowly return lever hook to original position. Hook will
6. Release the lever and pull thread away from you.
turn and pass thread through needle eye.
6. Release the lever and pull thread out about 10 cm from needle eye.
CAUTION! Do not lower the threader lever while machine is operating.
NOTE: For smooth threading it is recommended you select
straight stitching when using the needle threader.
NOTE: For smooth threading it is recommended you select straight stitching when
using the needle threader. Automatic needle threader cannot be used for double
needle.
1
4
NOTE: Automatic needle threader is only applicable for
Automatic needle threader cannot be used for double needle.
8
2
5
Texi Fox 25
3
6
zigzag presser foot.
EN
71