Removing Or Inserting The Bobbin Case; Inserting The Bobbin - Texi Joy 48 Manual De Operación

REMOVING OR INSERTING THE BOBBIN CASE

CAUTION: Turn off the power before start this operation.
Raise the needle by turning the balance wheel toward you.
1. Open the hook cover.
2. Take out bobbin case holding the latch.
3. When inserting the bobbin case, place the tip of the bobbin case into the recess of the hookrace.

INSERTING THE BOBBIN

1. Place bobbin into bobbin holder with the thread unwinding counter clockwise.
2. Draw thread into notch.
3. Pull thread toward the left and along the inside of spring until it slips into notch being sure that
thread does not slip out of notch. Pull thread out about 10 cm.
Texi Joy 48
gap
EN
67