Inserting The Needle; Connecting The Machine - Texi Tutu MC 9900 Manual De Operación

TEXI Tutu operation manual

INSERTING THE NEEDLE

Select a needle of the right type and size for the fabric to be sewn.
CAUTION: Turn off the power before removing the needle.
1. Turn the hand wheel toward you until the needle is at its highest
point.
2. Loosen the needle clamp screw.
3. Remove the needle.
4. Insert new needle into needle clamp with the flat side to the
back and push it up as far as it will go.
5. Tighten the needle clamp screw.
A.Do not use bent or blunt needles.
Place needle on a flat surface and check to see if bent.

CONNECTING THE MACHINE

Place the machine on a stable table.
1. Connect the power line cord to the machine by inserting
the 2-hole plug into the terminal box.
2. Connect the power line plug to the electric outlet.
3. Turn on the power switch.
4. A lamp will light up when switch is turned on.
To disconnect, turn the power switch to the off position,
then remove plug from outlet.
DANGER: Never leave the machine unattended when plugged in. Always unplug this machine from the electric
outlet immediately after using and before maintenance.
WARNING: Do not unplug by pulling on the cord. To unplug, grasp the plug, not the cord.
CONTROLL BUTTONS
A. START/STOP BUTTON
The machine will start running when the START / STOP is pressed and will
stop when pressed the second time. The machine will sew slowly first
stitches.
B. SLIDE SPEED CONTROL LEVER
When using START / STOP , the machine will sew faster when the slide
speed control lever is moved to the right and sew slower when the lever
is moved to the left.
C. LOW SPEED BUTTON
The machine will sew in low speed while holding the low speed . Press the START / STOP or foot control
to return to regular speed.
D. REVERSE STITCH BUTTON
Stitches 1, 2 and 6: The REVERSE STITCH will sew in reverse while the is pressed and return to foreward
stitching when the is released.
Other stitches: The REVERSE STITCH will sew 3-4 stitches to tie-off the stitching and then stop sewing.
Continue sewing by pressing the START / STOP or foot control.
E. NEEDLE UP / DOWN BUTTON
When presser foot is down, the needle can be raised or lowered by pressing this button. When the presser foot
is up, press this for one complete stitch.
3
124