Riester RVS-100 Manual Del Usuario página 73

Appendix B: Factory Defaults
This chapter is about factory defaults setup. The user can't change the factory defaults. Qualified personnel must input a
password through 【 SETTINGS 】 →【ADVANCED 】 to change the factory defaults.
B.1 Date /Time
Date /Time general setting
Date type
Time zone
B.2 Alarm
Alarm setup
ALM Volume
Allow closing of general alarm
Alarm pause time
Allow control alarm audio
Alarm control
Active reminder signal
Remind signal interval
B.3 Display
Display general setup
Battery working time
B.4 Others
Others general setup
Power supply frequency
B.5 SpO
2
SpO2 setup
SPO2 display
Wave Speed
B.6 NIBP
NIBP setup
NIBP display
Default patient type
Unit
Inflation pressure
B.7 Temp
Temp setup
Unit
Appendix C: Guidance and Manufacturer's Declaration of EMC
Guidance and manufacturer's declaration – electromagnetic emissions
Guidance and manufacture's declaration – electromagnetic emission
The monitor is intended for use in the electromagnetic environment specified below. The customer or the user of the monitor
Factory Defaults
Year/month/day
GMT +8
Factory defaults
Low
No selection
2 min
No selection
Alarm audio on
Yes
30 sec
Factory defaults
10min
Factory defaults
50Hz
Factory defaults
SPO value
2
25mm/s
Factory defaults
Display as SYS/DIA
Adult
mmHg
Adult170 mmHg
Pediatric 130 mmHg
Neonatal 90 mmHg
32
Factory defaults
℃
-­for all EQUIPMENT and SYSTEMS
73