VM Motori D703E2 Manual De Instrucciones página 141

CONTROL SCREW TIGHTENING AND UNION SEALING
Follow the procedure below.
1- Start the engine and run it at minimum
speed for a few minutes.
2-Run the engine at normal speed until
the operating temperature (70÷80°C) is
reached.
3- Turn off the engine and let it cool down.
ENGINE OIL LEVEL CONTROL
Follow the procedure below.
1- Start the engine and bring it to the
operating temperature (70÷80 °C).
2- Turn off the engine and remove the
ignition key.
3- Place the engine on a perfectly level
surface.
4-Wait a few minutes so that all the oil
will flow into the sump.
5- Remove the dipstick (L) and check the
oil level.
6- Top up, if necessary, from plug (M).
When topping up the oil, to avoid excee-
ding the maximum allowed value, add the
oil in small amounts (100 to 200 ml at a
time) until it reaches the correct level.
The oil level should be included
between the minimum and maximum
marks.
Do not mix oils of different brands or
with different features (See "Recom-
mended lubricants").
English
D700-750E2_E3
4- Make sure the fixing screws of the main
parts are tightened properly.
5- Check the union sealing on the fuel
supply circuit.
6- Check the tightening of the clamps.
7- Check any fluid leaks.
Oil Dipstick (L)
Filler Cap (M)
61
VM p/n 42432097F Ed.4 - 2015-05
GB