VM Motori D703E2 Manual De Instrucciones página 122

START-UP
- Engines on pallets
GB
Remove the covers and protective
elements applied to the engine open-
ings (for instance, air suction ducts
or turbocharger air inlet, exhaust gas
ducts or turbocharger guard).
Check there is no damage to the ex-
ternal engine components; make any
necessary repairs.
Clean the throats of the metal belt pul-
leys, using a suitable solvent. Install
the service belts
Check the rubber tubes and manifolds
are in good condition, and check the
tightening of the relative fixing clips; if
they are damaged, replace them.
All surfaces and components pro-
tected with "FL MECAFLUID / P118 V"
protective oil can be cleaned with a
suitable solvent.
Check the level of the fluids: engine oil
and coolant. Top up if necessary.
- Engines on vehicles
Check there is no damage to the ex-
ternal engine components; make any
necessary repairs.
Clean the throats of the metal belt pul-
leys, using a suitable solvent. Install
the service belts.
Check the rubber tubes and manifolds
are in good condition, and check the
tightening of the relative fixing clips; if
they are damaged, replace them.
All surfaces and components pro-
tected with "FL MECAFLUID / P118 V"
protective oil can be cleaned with a
suitable solvent.
English
D700-750E2_E3
Check the level of the fluids: engine oil
and coolant. Top up if necessary.
Nothing needs to be done to remove the
internal protection (either for engines on
pallets or on vehicles).
42
VM p/n 42432097F Ed.4 - 2015-05