Engine Oil Change - VM Motori D703E2 Manual De Instrucciones

ENGINE OIL CHANGE

Follow the procedure below.
1- Turn off the engine and remove the
ignition key.
2- Let the engine cool down adequately
to avoid being burnt.
3- Prepare a container of appropriate
capacity.
As for the oil quantity, see "Technical
data".
4-Unscrew the plug (P).
5-Unscrew the exhaust plug (Q) and let
all the oil flow into the container.
6-Replace the gasket and screw plug
(Q) back into place.
Lock the plug to a torque of 55 Nm.
7- Pour the new oil through the filling
plug (P).
To reach the correct engine oil level, add
the minimum oil quantity depending on
the engine model (see "Technical data").
Then top up.
When topping up the oil, to avoid
exceeding the maximum allowed value,
add the oil in small amounts (100 to 200
ml at a time) until it reaches the correct
level.
The oil level must be between the
minimum and maximum marks on the
dipstick.
8- Screw again the plug (P).
9- Start the engine and bring it to the
operating temperature (70÷80 °C).
Check for any oil leaks
English
D700-750E2_E3
Filler cap (P)
Discharge cap
(Q)
In the event of oil leaks, check the level
periodically to evaluate the extent of
the leak. If the amount is excessive,
contact one of the manufacturer's
authorised service centres.
10-Turn off the engine and check the oil
level.
– Do not throw the oil in the envi-
ronment but carry out its disposal in
compliance with legislation in force in
the country where it is used.
– Use the oils and lubricators recom-
mended by the manufacturer (See
"Recommended lubricants").
63
VM p/n 42432097F Ed.4 - 2015-05
GB