Oil Filter Cartridge Replacement - VM Motori D703E2 Manual De Instrucciones

OIL FILTER CARTRIDGE REPLACEMENT

Follow the procedure below.
1- Turn off the engine and remove the
ignition key.
2- Let the engine cool down adequately
to avoid being burnt.
3- Prepare a container to collect any
leak.
4-Unscrew filter (U) and replace it.
5-Check the conditions of gasket (V)
and, if necessary, replace it.
6- Lubricate the seal of the new cartridge
before assembling it.
7- Install the oil filter.
Lock the screw to a torque of 12,7 Nm.
8- Turn the engine on and leave it run-
ning at minimum speed for a few minutes
until it reaches working speed (70÷80°C).
9- Turn off the engine and remove the
ignition key.
10-Wait a few minutes so that all the oil
will flow into the sump.
11-Check that the oil level is correct and
top up if necessary.
When topping up the oil, to avoid excee-
ding the maximum allowed value, add
the oil in small amounts (100 to 200 ml at
a time) until it reaches the correct level.
The oil level must be between the
minimum and maximum marks on the
dipstick.
12-Check for any oil leaks
English
D700-750E2_E3
In the event of oil leaks, check the level
periodically to evaluate the extent of
the
leak. If the amount is excessive, con-
tact one of the manufacturer's authori-
sed service centres.
Do not throw away any polluting
material in the environment. Carry out
their disposal in compliance with the
relevant legislation in force.
65
VM p/n 42432097F Ed.4 - 2015-05
Oil filter (U)
O-ring (V)
GB