Stopping The Engine - Yanmar 6LPA-DTP Operación Manual

4.7 Stopping the Engine

Stop the engine in accordance with the following
procedures.
①Stop the boat.
Put the remote control handle in NEUTRAL to
stop the boat.
②Be sure to race the engine before stopping it.
③Cool down the engine at low speed (1000rpm
or lower) for about 5 minutes.
④Continue to push the stop button until the
engine is completely stopped. If you release
the button before the engine has completely
stopped, it may restart.
⑤Turn the starter switch to OFF , remove the key
and place it in a safe place.
⑥Turn off the battery switch.
⑦Close the fuel tank cock.
⑧Close the kingston cock.
In the rare instance where the engine does not
stop when the stop button is pushed, stop the
engine by closing the fuel cock on the fuel tank.
→See 4.6 (7)
_ 31 _
[NOTICE]
Stopping the engine suddenly after
operating at high speed without cool-
ing it down will cause the engine tem-
perature to rise quickly resulting in
deterioration of the lube oil and stick-
ing of parts.
[NOTICE]
Neglecting to close the kingston cock
will allow water to leak into the boat
and may cause it to sink. Be sure to
close the cock.