Fire-Fighting; Moving The Machine - Nussbaum TC 110 PRO Manual De Instrucciones

(1*/,6+ ‡ ,QVWUXFWLRQV PDQXDO
example ESSO Febis K68; Mobil Vactra 2; Shell Tonna Oil 68).
4) To ensure correct operation of the inflation device pressure limiter (Refer to the section on "SAFETY DEVICES", p. 19 of this
manual, it is essential to carry out the following routine checks:
- Check the water level in the water trap to the air supply (2, Fig. S), which must NEVER exceed the "MAX DRAIN" level indica-
tor on the water trap itself.
When necessary, drain the water by turning the locking ring (3, Fig. S) clockwise.
- Every 30-40 days disconnect the machine from the compressed air circuit and dismantle the glass (2, Fig. S) to remove any
solids collected inside it.
WARNING!
If this machine catches fire, only use powder extinguishers or, alternatively, CO
flames.
Follow the procedures outlined below when moving the machine:
1) Close the turntable grippers all the way towards the centre.
2) Turn the table so to position the slots on the turntable plate as shown in Fig. T/1.
3) Disconnect all power sources.
4) Sling the machine with lifting straps at least 60 mm wide.
5) Pass the first strap under the horizontal arm (1, Fig. T/2) as to insert it between
the post (2, Fig. T/2) and the nut (3, Fig. T/2) which locks the arm pin.
6) Pass the second strap between the two front slots on the turntable plate as
shown in Fig. T/1.
7) Pass the straps through a lifting hook above the machine as shown in Fig. T/3.
8) Hoist and move the machine with
a sufficiently strong lift truck.

13. FIRE-FIGHTING

14. MOVING THE MACHINE

2
47
2
1
3
T/2
extinguishers to put out the
T/1
T/3
TC 110 PRO