Electric Hook Up; Identification Of Parts - Nussbaum TC 110 PRO Manual De Instrucciones

6.6 ELECTRIC HOOK UP

Before making any electric hook up, check to be certain that the mains voltage corresponds to what is stamped on the voltage tag
(attached on the feeding cable of the tyre changer).
It is absolutely essential that the system is equipped with a good grounding circuit.
The machine must be connected to a power supply line circuit breaker set for 30mA.
Note the required power draw as highlighted on the tag-plate fixed to the back of the tyre changer.
Check to make sure the shop electric wiring circuit is dimensioned sufficiently to carry this.
WARNING!
Work on the electric system, even if minor, must be done exclusively by professionally qualified personnel.
Manufacturer shall not be liable for any injury to persons or damage to things caused by failure to comply with these regulations and
can cancel warranty coverage.
1- Table top rotate pedal
2- Table top
3- Bead breaker (loosener) pedal
4- Bead breaker arm
5- Table top clamp opening/closing pedal
6- Wheel clamp
7- Lever for exagonal arm regulation
8- Hexagonal arm
9- Horizontal arm
10- Filter and lubricator
11- Rubber wheel support
12- Bead breaker shoe
13- Mounting/demounting head
14- Tyre lever
15- Handle for horizontal arm regulation
16- PT40 device
17- Articulated arm
18- PT40 control lever
19- Mobile bead depressor locking handle
20- Mobile bead depressor
21- Bead depressor pad
22- Rim pressing tool cone
23- BPR bead depressor roller
24- PTR roller bead depressor
25- WDK Kit
26- Bead pressing clamp
TC 110 PRO
7. IDENTIFICATION OF PARTS (FIG. H)
18
17
19
15
16
20
21
22
24
10
2
26
25
32
(1*/,6+ ‡ ,QVWUXFWLRQV PDQXDO
7
9
8
13
23
6
14
11
3
1
5
4
12
H
H