Assembly - Nussbaum TC 110 PRO Manual De Instrucciones

WARNING: Use the fixing plates (Fig. B), which locks the tyre changer on the pallet,
for fixing the machine on the ground after unpacking.
3- Slide the tyre changer sideways from the pallet with the greatest care.
N.B.: Keep the packing material out of the reach of children as it can be a
source of danger.
Take the packing materials to an appropriate solid waste disposal pick up point
if they are polluting or non-biodegradable.

6.3 ASSEMBLY

1) Set up the vertical post (1, Fig. C) on the body (2, Fig. C) and fix it with
nuts and washers (3, Fig. C).
2) Fix the lubricator and regulator unit (4, Fig. C) to the vertical post by using
the screws (5, Fig. C).
3) Use the lever (6, Fig. D) to lock the hexagonal arm in the limit (fully up)
position.
4) Use a size 6 spanner to undo the screw which fixes the knob (7, Fig. D).
5) Fit the spring onto the hexagonal post.
Place the knob on the post and keep it pressed down slightly to allow it to be
secured using the screw removed earlier. Tighten fully.
6) Release the hexagonal arm.
7) Screw the arm position regulator handle onto the vertical post (see Fig. E).
8) Fit the tyre paste container support ring (8, Fig. C) into the holes pro-
vided on the right-hand side of the tyre changer.
9) Remove the countersunk cap screw (9, Fig. F), the washer (10, Fig. F) and
TC 110 PRO
F2
30
(1*/,6+ ‡ ,QVWUXFWLRQV PDQXDO
1
3
8
7
9
12
5
4
2
C
6
D
E
11
10
12
F