Safety Devices; Transport; Installation; Installation Place - Nussbaum TC 110 PRO Manual De Instrucciones

(1*/,6+ ‡ ,QVWUXFWLRQV PDQXDO
TC 110 PRO tyre changer is equipped with a pneumatic built-in safety valve.
This valve prevents pressure coming from inflating gauges, or other inflating devices connected to the tyre changer, to exceed 3.5 bar.
ATTENTION: Removing or tampering with the safety devices installed on this machine is in violation of European
Safety Regulations and relieve NUSSBAUM GmbH from all liability.
The machine is delivered in a carton box with pallet.
Shipping weight for TC 110 PRO is 245 kg.
The machine must be handled with a fork-lift truck with the forks positioned as shown in
the figure A.

6.1 INSTALLATION PLACE

Position the tyre changer, still in its packing, in the chosen installation site.
Remember that:
1 - The area required to install the machine measures 2050 mm in width and 1160 mm in depth.
Keep at least 500 mm away from walls.
2 - The floor must be solid, level and able to bear the weight of the machine without yielding.
3 - The installation site must be equipped with an electrical system with an efficient grounding
circuit and automatic differential circuit-breaker with 30 mA setting.
4 - The installation site must be equipped with a connection to a compressed air network with
an operating pressure of at least 8 bar.

6.2 UNPACKING

1 - Remove the tyre changer from the packing and check to make sure that the machine is in
a perfect condition. Make sure that there are no visibly damaged parts.
2 - Remove all the screws that fix the machine to the pallet, using a N° 13 setscrew wrench.

4. SAFETY DEVICES

5. TRANSPORT

6. INSTALLATION

29
A
B
TC 110 PRO