SC Series Controllers
Configuration
● Tool Configuration Fault- "See Chapter Fault Guide [} 118]" for explanation of fault.
● Servo Connection Fault- "See Chapter Fault Guide [} 118]" for explanation of fault.
● Spindle Communications- "See Chapter Fault Guide [} 118]" for explanation of fault.
● GFI Fault- "See Chapter Fault Guide [} 118]" for explanation of fault.
● Battery Pack Fault- "See Chapter Fault Guide [} 118]" for explanation of fault.
● Low Battery- "See Chapter Fault Guide [} 118]" for explanation of fault.
● Heatsink Temperature Fault- "See Chapter Fault Guide [} 118]" for explanation of fault.
● Overvoltage Fault- "See Chapter Fault Guide [} 118]" for explanation of fault.
● Tool Jammed- "See Chapter Fault Guide [} 118]" for explanation of fault.
● Parameter Changed- A parameter within the spindle was modified and saved.
● Spindle Connected- The spindle was connected and communicating successfully.
● Spindle Disconnected- The spindle was disconnected or communication error.
● Firmware Update- The firmware on the spindle was updated successfully.
● Powered On- The spindle was powered on from an off state.
● Log Cleared- The event log was cleared.
● Network Status Change- The spindles network protocol status has changed state.
● Cpks Limit- The capability index fell below the programmable minimum Cpk limit.
● Ppks Limit- The statistical capability index fell below the programmable minimum Ppk limit.
● CAMs Limit- The statistical capability index fell below the programmable minimum CAM limit.
● X Bar Trend- The audit value's average statistical trend is drifting up or down.
● Log File Error- Please contact a STANLEY service team member.
● Internal Fault- Please contact a STANLEY service team member.
● Time Changed- The internal spindle clock time or date was modified and saved.
● PM Counter Reset- The preventative maintenance counter was rest to zero.
● Trip Counter Reset- The trip counter was reset to zero.
● Unknown- The event error was not recognized, most likely due to mismatched software between Alpha
Toolbox, lead spindle, and trailing spindles.
8.3.2.2
Log menu
Clear: It clears all the logs. Press the clear interactive button a popup appears "Are you Sure?". Pres Ok to clear
all the logs.
Import: Imports the logs CSV file from the USB stick.
Go to Analyze -> Logs -> Import -> Select the path in the USB stick -> Ok
Export: Export the logs data into the USB stick.
Go to Analyze -> Logs -> Export -> Select the path in the USB stick -> Ok
8.3.3
Statistics
Under Analyze Card header -> Select Statistics Card
98 / 1032
