XML Communications
Enable or Disable XML communications as required. Once enabled select the correct software and results
server and ports.
● Version
Now supports version 2.0, 2.1 and 2.2. Choose the correct one for the facility.
● Results Server
Input the IP Address of the Results Server on the network.
● Results Port
The virtual port on the XML protocol network server where the SC controller transmits messages.
● Command Port
The virtual port where the SC controller receives commands from the XML protocol network server.
Save the changes.
8.1.2.8
Pair
Under Setup card header -> Select Communications card -> Select Pair button from menu bar
Press the Pair interactive menu button, available on SC controller, to initiate the pairing mode to a QPM
Cordless Tool. If there are unsaved changes, the changes must be saved before you can put the controller in
pair mode.
The "Pair" button will switch the access point to a pairing SSID while the SC controller is in pairing mode.
To pair a QPM Cordless Tool, start with the tool powered off by removing and reinstalling the battery pack. Next,
Wake the QPM Cordless Tool into pairing mode by pressing and holding the MFB and then tapping the start
trigger switch. Wait for the tone before releasing the MFB. The QPM Cordless Tool will search for the wireless
capable SC controller and request to be added as a trailing spindle by flashing, the status lights in sequence.
Accept the QPM Cordless Tool as a trailing spindle in the notification window that appears on the wireless
capable SC Controller. The cordless tool will disconnect from the pairing network, then reconnect on the
controller network to complete pairing. Once the QPM cordless tool will reconnected, then the paring is done.
"See Chapter Connection [} 112]" to see how to accept the spindle as a trailing device.
8.1.3
I/O
Under Setup Card header-> Select I/O Card
Discrete Outputs
The 24V DC Connector has pins C through K designated as Outputs from the controller. The pin assignments
are selectable on this Discrete Outputs Card.
Under Setup Card header -> Select I/O Card -> Under Discrete Outputs Card header-> Select an output
card(pin) -> Select an output function from the dropdown list on the right side of the screen.
A list of available output functions displays. "See Chapter Assignable Input and Output Functions [} 61]" for the
complete list and descriptions.
SC Series Controllers
Configuration
59 / 1032
