6
Assembly
6.1
Installation instructions
DANGER
Electrical Hazard
To avoid injury from electrical current
⇒ This product should be located away from heat sources such as radiators or other devices that produce heat.
⇒ This product should not be subjected to vibration or shock or in close contact with water or other liquids.
⇒ To minimize electrical interference, place the module as far away from possible sources of electrical noise,
such as arc welding equipment.
⇒ Install tools and controllers in dry, indoor, non-flammable, and non-explosive environments only.
⇒ Do not use this product near water, for example near a washbowl, wet basement, or the like.
⇒ Avoid body contact with electrically energized surfaces when holding a grounded tool.
Please refer to the pictures of a plinth and mounting of the SC controller "See Chapter Plinth Mounting
Dimensions [} 18]". Plinths connect to each other with four 10-32 machine screws through openings on the top
and right side to threaded openings on the bottom and left side. When mounting plinths are placed next to each
other, the center-to-center distance between the mounting holes in different plinths is 2" (50.8 mm). When
mounting plinths are place one above another, the center-to-center distance between the mounting holes in
different plinths is 6" (152.4 mm).
1. Install the SC controller either directly to the wall or to a plinth (part number 21E204300).
2. Fasteners through four mounting holes secure plinths to a wall or other surface. Plinths can be connected
using 10-32 threaded holes on the bottom and left side and through holes on the top and right side.
3. Make sure the bolts of the barrel-latches [5] on the plinth are retracted. Place the lower flange of the SC
controller [1] into the lip [2] on the plinth.
4. Align the slot [3] in the flange with the lower mounting-pin [4] on the plinth while placing. Rotate the top of
the controller back towards the plinth.
5. Place the openings on the upper flange of the controller [6] over the upper mounting pins [7] on the plinth.
Release the bolts on the barrel-latches [5] making sure the bolts enter the two barrels [8] on the controller.
6. Connect the SC controller to a power source.
7. Connect one end of the tool cable to the tool and the other end to the SC controller and press the power
switch on the controller.
SC Series Controllers
Assembly
29 / 1032
