SC Series Controllers
Configuration
Outputs
Description
*RUNDOWN BOLT This is the accumulated bolt count value of the last fastening cycle. It asserts when the
fastening cycle is complete (after the IN CYCLE bit resets). The value resets to zero (0)
when the tool is commanded to run again.
Size: Can be any size from 0 to 32 bytes depending on Data Type
Data Type: Float, Int8, Int16, Int32, Fixed Point, String
Spindle: Type the spindle number from which the signal comes.
*RUNDOWN DAY This is the day value of the last fastening cycle date. It asserts when the fastening cycle is
complete (before the IN CYCLE bit resets). The value resets to zero (0) when the tool is
commanded to run again.
Size: Can be any size from 0 to 32 bytes depending on Data Type
Data Type: Float, Int8, Int16, Int32, Fixed Point, String
Spindle: Type the spindle number from which the signal comes.
*RUNDOWN
This is the hour value of the last fastening cycle time. It asserts when the fastening cycle is
HOUR
complete (before the IN CYCLE bit resets). The value resets to zero (0) when the tool is
commanded to run again.
Size: Can be any size from 0 to 32 bytes depending on Data Type
Data Type: Float, Int8, Int16, Int32, Fixed Point, String
Spindle: Type the spindle number from which the signal comes.
*RUNDOWN JOB
This value indicates the job in which the last fastening cycle was performed. It asserts
when the fastening cycle is complete (before the IN CYCLE bit resets). The value resets to
zero (0) when the tool is commanded to run again.
Size: Can be any size from 0 to 32 bytes depending on Data Type
Data Type: Float, Int8, Int16, Int32, Fixed Point, String
Spindle: Type the spindle number from which the signal comes.
*RUNDOWN
This is the minute value of the last fastening cycle time. It asserts when the fastening cycle
MINUTE
is complete (before the IN CYCLE bit resets). The value resets to zero (0) when the tool is
commanded to run again.
Size: Can be any size from 0 to 32 bytes depending on Data Type
Data Type: Float, Int8, Int16, Int32, Fixed Point, String
Spindle: Type the spindle number from which the signal comes.
*RUNDOWN
This is the month value of the last fastening cycle date. It asserts when the fastening cycle
MONTH
is complete (before the IN CYCLE bit resets). The value resets to zero (0) when the tool is
commanded to run again.
Size: Can be any size from 0 to 32 bytes depending on Data Type
Data Type: Float, Int8, Int16, Int32, Fixed Point, String
Spindle: Type the spindle number from which the signal comes.
*RUNDOWN PART
This is the PART ID value of the last fastening cycle date. It asserts when the fastening
ID
cycle is complete (before the IN CYCLE bit resets). The value resets to zero (0) when the
tool is commanded to run again.
Size: Can be any size from 0 to 32 bytes depending on Data Type
Data Type: Float, Int8, Int16, Int32, Fixed Point, String
Spindle: Type the spindle number from which the signal comes.
*RUNDOWN
This is the second value of the last fastening cycle time. It asserts when the fastening
SECOND
cycle is complete (before the IN CYCLE bit resets). The value resets to zero (0) when the
tool is commanded to run again.
Size: Can be any size from 0 to 32 bytes depending on Data Type
Data Type: Float, Int8, Int16, Int32, Fixed Point, String
Spindle: Type the spindle number from which the signal comes.
74 / 1032
