Inputs
Description
Bit: Type the number this bit to be in the binary number scheme to verify a job.
Mode: All JOB VERIFY BITs must be the same mode, no mixing of modes allowed.
Binary – Creates a decimal number equivalent to the weighted value of this binary bit(s).
Binary + 1 – Creates a number equivalent to the weighted value of this binary bit(s) plus 1.
Spindle: Type the spindle number for which the job is to be verified.
*PART ID
When asserted on any fieldbus input, the controller reads the new PART ID input and places
the data into the Part ID buffer. This is added to the fastening cycle data and stored in the
controller. This input function is NOT available on the 24V DC input bus.
Size: Can be any size from 1 to 32 bytes.
When removed nothing happens.
Length: Type the length of the expected data string in bits.
Spindle: Type the spindle number to receive the PART ID data.
RESET JOB
When asserted, on any input, the controller resets the accumulated bolt count to zero for the
active job and acts as a part entry to re-enable the tool if disabled. The tool could be disabled
due to "Error Proofing" and the accumulated bolt count equal to target bolt count.
When removed nothing happens.
Size: 1 bit
Contact Type: Normally Open (N.O.), Normally Closed (N.C.)
Spindle: Type the spindle number in which the job is to be reset.
RESET
When asserted on any input bus, the controller resets to 0 (zero) any fastening cycle results
RESULT
status output bit on the same bus. Meaning, if asserted on DeviceNet, only the DeviceNet
STATUS
output status bits are reset. Output status bits on other buses will remain in their original state.
The list of status bits that will reset are:
CYCLE OK CYCLE NOK
TORQUE OK TORQUE HIGH
TORQUE LOW ANGLE OK
ANGLE HIGH ANGLE LOW
CYCLE ABORTED CYCLE STOP
CURRENT OK CURRENT HIGH
CURRENT LOW
When removed nothing happens.
Size: 1 bit
Contact Type: Normally Open (N.O.), Normally Closed (N.C.)
Spindle: Type the spindle number in which the result status is to be reset.
REVERSE
When asserted on any input bus, the tool is placed in Reverse (disassembly) mode. This does
NOT run the tool in Reverse mode, it changes the tool mode from Forward to Reverse. If one
input is required to do both functions, see REVERSE START.
When removed, from any input type, the controller places the tool into Forward (assembly)
mode.
Size: 1 bit
Contact Type: Normally Open (N.O.), Normally Closed (N.C.)
Spindle: Type the spindle number for the tool to be put into reverse.
SELECT JOB
When asserted, on any input type, the controller makes this input's Job the active Job.
When removed either nothing happens or if "Disable when open" is set to yes, then the tool
becomes disabled.
Size: 1 bit
Contact Type: Normally Open (N.O.), Normally Closed (N.C.)
SC Series Controllers
Configuration
65 / 1032
