SC Series Controllers
Configuration
Password
This parameter sets the encryption key needed to connect a wireless device to the access point in the SC
controller. Must be a minimum of 8 characters and no longer than 63 printable characters or 64 hexadecimal
digits.
This parameter can be left blank unless a security protocol is selected.
Join Network
The join network generates a QR code used to connect computers or other devices with browsers to Alpha
Toolbox.
8.1.2.2
TCP/IP
Under Setup card header -> Select Communications card -> TCP/IP
This information is required when connecting the SC controller to an Ethernet network using the Ethernet port.
Obtain IP From Network
Enable, allows the SC controller to receive an address from the network DHCP server. Disable, the address
parameters need to be filled in manually.
IP Address
The IP Address of the SC controller.
Subnet Mask
The Subnet address of a SC controller.
Gateway
The Gateway address to a connecting network.
DNS
The address of the network's DNS server.
Physical
This is the MAC id of the Ethernet port on the SC controller. This value comes from the Ethernet board inside
and cannot be changed.
Lead Spindle
Enable, trailing Plant network port will act as aTB port(Static IP). Disable, will act as trailing plant network
(Dynamic IP)
53 / 1032
