Snug force
The point in the step when the controller begins to monitor the tool's output distance. Should be greater than 0
and less than Low force. Units are the selected force units(kN).
High force
The maximum peak force for an acceptable fastening cycle (required for all steps). If the actual force exceeds
this limit the fastening cycle will be flagged as NOK and the RED LED on the front panel and tool illuminates.
Units are the selected force units(kN).
Low force
The minimum peak force for an acceptable fastening cycle. If the actual force does not reach this limit, the
fastening cycle is flagged as NOK and the YELLOW LED on the front panel and tool illuminates. Units are the
selected force units(kN).
High Distance
The maximum peak distance for an acceptable fastening cycle (required for all steps). If the actual distance
exceeds this limit the fastening cycle will be flagged as NOK and the RED LED on the front panel and tool
illuminates. Must be greater than Low Distance. Units are in mm.
Low Distance
The minimum peak distance for an acceptable fastening cycle. If the achieved distance does not reach this limit
the fastening cycle will be flagged as a NOK and the YELLOW LED on the front panel and tool illuminates. Must
be less than High Distance. Units are in mm.
Travel past Break
The distance from the breaking point to the Revit pulled back.
Monitor force window
If enabled, provides a force window during the rundown phase of the fastening cycle into which achieved force
must pass through. This window looks back from the Snug force of the step over the distance interval defined. If
achieved force is outside the window the fastening cycle is ended with the Shutoff Code of [T].
1. Upper force
Defines the high force limit for the window.
2. Lower force
Defines the low force limit for the window.
3. Upper distance
Defines the low distance limit for the window referenced from when the Snug force value.
4. Lower distance
Defines the high Distance limit for the window referenced from when the Snug force value.
SC Series Controllers
Configuration
51 / 1032
