SC Series Controllers
Configuration
Outputs
Description
IN CYCLE
Asserts during the fastening cycle when the achieved torque value exceeds the Threshold
Torque value. Resets when the fastening cycle has ended.
Size: 1 bit
Contact Type: Normally Open (N.O.), Normally Closed (N.C.)
Output Type: Normal, Timed, Flash
Minimum ON Time, Time, Period
Spindle: Type the spindle number from which the signal comes.
IN REVERSE
Asserts when the tool's operation is set to Reverse. Resets when the tool's operation is set
to Forward.
Size: 1 bit
Contact Type: Normally Open (N.O.), Normally Closed (N.C.)
Output Type: Normal, Timed, Flash
Minimum ON Time, Time, Period
Spindle: Type the spindle number from which the signal comes.
JOB COMPLETE
Asserts when a job is completed (accumulated bolt count equals target bolt count). NOTE:
not all bolts may be OK. Resets when a different job is selected or when the input RESET
JOB is asserted.
Size: 1 bit
Contact Type: Normally Open (N.O.), Normally Closed (N.C.)
Output Type: Normal, Timed, Flash
Minimum ON Time, Time, Period
Spindle: Type the spindle number from which the signal comes.
JOB OK
Asserts when a job is completed (accumulated bolt count equals target bolt count) and all
bolts are OK. Resets when a different job is selected or when the input RESET JOB is
asserted.
Size: 1 bit
Contact Type: Normally Open (N.O.), Normally Closed (N.C.)
Output Type: Normal, Timed, Flash
Minimum ON Time, Time, Period
Spindle: Type the spindle number from which the signal comes.
JOB SELECTED
Asserts when a job is selected by any means. Resets when the active job is complete.
Size: 1 bit
Contact Type: Normally Open (N.O.), Normally Closed (N.C.)
Job: Type the job number that, when selected, asserts this output.
Output Type: Normal, Timed, Flash
Minimum ON Time, Time, Period
Spindle: Type the spindle number from which the signal comes.
JOB SELECTED
Asserts when required to indicate the active job. This is one bit in a series of bits to create
BIT
a binary number. As jobs change so will the binary number created from these bits.
Size: 1 bit
Contact Type: Normally Open (N.O.), Normally Closed (N.C.)
Bit: Type the number this bit to be in the binary number scheme for selected jobs.
Mode: All JOB SELECTED BITs must be the same mode, modes cannot be mixed.
Binary – Creates a decimal number equivalent to the weighted value of this binary bit(s).
Binary + 1 – Creates a number equivalent to the weighted value of this binary bit(s) and
adda the value of one (1) to that number.
72 / 1032
