8.1.6.1
User configuration
Under Setup Card Header -> Select Users card
1. Select the user card then navigate to the particular user page, select the dropdown of the Administrator
card. Configure access.
2. To assign the selected user as an Administrator choose Yes, for non-administrators choose NO, then press
OK Save.
3. One user must be an Administrator. Administrator rights give a user full access to the controller. This
enables all privileges including restoring factory defaults, deleting logs and adding users.
Options include:
There is no overlap between areas. Select more than one area for access if required.
Setup
Users at this level can modify all parameters in the Job area. They may also modify
parameters in the Other area except in the Users, Tool and Stats tabs.
Tool
Users at this level can modify parameters under the Tool tab in the Other area, as well
as set Preventive Maintenance Threshold and reset the PM and Cycle counters in the
SERVICE menu.
Diagnostics
Users at this level can force Inputs or Outputs ON or OFF and REMOVE forces in the I/
O tab of ANALYZE.
Statistics
Users at this level can modify parameters under the Stats tab in the Other area.
Communications
Users at this level can modify all parameters in the Communications area.
Access options
NONE
Denies access.
LOCAL
Allows access from the keypad.
REMOTE
Allows access from a computer via Alpha Toolbox.
BOTH
Allows access from the keypad and a computer.
8.1.7
Other
Under Setup Card Header-> Select Other Card
This area sets the parameters for all other SC controllers features, including General functions, Triggers, Lights,
Tones, Tool functions, Statistics, Regional. Each category is represented by its own menu.
8.1.7.1
General
Under Setup Card Header -> Select Other Card -> General
Lock Keypad
Option available only in Alpha Toolbox. When enabled the SC controller keypad cannot be used to edit any
parameters. It will allow the user to navigate through the system and view any parameters. If the keypad is
locked and it is desired for it to be unlocked one must connect to Alpha Toolbox on the controller and disable
this parameter. If set to disable the keypad on the SC controller can be used to edit parameters.
SC Series Controllers
Configuration
85 / 1032
