The X axis zero point for Time is when the achieved torque reaches or exceeds Task's Threshold Torque value.
The X axis zero point for Angle is when the achieved torque reaches or exceeds the audit step's Snug Torque
value. Time and Angle values between start and the zero point are negative.
Slide the bottom scroll button to move the graph to right or left.
Slide the right scroll button to move the graph to up or down.
8.3.1.2.1
Points on graph
Crosshairs and a point information box appear at the point where the mouse hovers over the graph. The X and
Y axes information is presented in the point information box. Move the mouse on the X and Y axes and the
values change in the point information box.
8.3.1.2.2
Events
The dots on the graphs indicate events that occurred during the fastening cycle. Events are things such as
Threshold Exceeded, ATC Active and Control Point strategy functions (target achieved). The event is indicated
when the mouse hovers over the event point on the graph.
8.3.1.2.3
Overlay
Multiple fastening cycle graphs can be layered on top of one another. Click on the Rundown and then click on
the miniature trace box to lock the trace for viewing. More than one trace may be pinned/locked. Each pinned
trace will draw on the right and overlay on top of each other.
The zero point of the X axis of Time for each graph in overlay view is the programmed Threshold Torque. The
zero point changes to the programmed Snug Torque.
Selected and pinned fastening cycles will move down the list as new ones come into the list. Use the scroll bar
to view and unpin the older traces.
8.3.1.2.4
Trace menu
8.3.1.2.4.1
Details
Click on the detail button to display information about the selected fastening cycle.
Rundown – Indicates the unique number for the fastening cycle. Date – The date the fastening cycle occurred.
ID: The sequential number of the fastening cycle data
Date: Date of the fastening cycle occurred.
Time – The time of the fastening cycle occurred.
Job – The Job in which the fastening cycle occurred.
Task – The Task in which the fastening cycle occurred. Status – Overall status of the fastening cycle.
Status: The overall status of the fastening cycle.
SOC: Shutoff Code, see relevant section for more information.
Job Count – The working bolt of the Job during this fastening cycle.
SC Series Controllers
Configuration
95 / 1032
