39 9.4 Brake Dynamometer Series Bd 6Xx; 40 9.5 Side Slip Tester St; Faults; 41 9.6 Chassis Tester Sa / Sn 6Xx - Beissbarth SL 6 Serie Manual Original

en 68 | SL 6xx | Fault procedure
9.4 Brake dynamometer series BD 6xx
9.4.1 Warnings
Explanation
Error
1 Vehicle on set of rollers when switched on
2 Front left scales sensor cable break
3 Rear left scales sensor cable break
4 Front right scales sensor cable break
5 Rear right scales sensor cable break
7 Zero point too high – left braking force sensor
8 Zero point too high – right braking force sensor
9 Zero point too high – front left scales sensor
1 0 Zero point too high – rear left scales sensor
1 1 Zero point too high – front right scales sensor
1 2 Zero point too high – rear right scales sensor
1 3 Zero point too high – pedal force sensor
1 4 Different position of slip rollers in automatic / super
automatic mode
1 5 Not possible to store measurement
1 6 Direction reversal not supported by power box
9.4.2

Faults

Explanation
Error
1 Left braking force sensor cable break
2 Right braking force sensor cable break
3 Left wheel slip roller cable break
4 Right wheel slip roller cable break
5 Left slip roller cable break
6 Right slip roller cable break 7 Amplifier defective – left wheel slip roller
8 Amplifier defective – right wheel slip roller
9 Amplifier defective – left slip roller
1 0 Amplifier defective – right slip roller
1 1 Slip roller spring broken
1 3 Sensor defective – left slip roller
1 4 Sensor defective – right slip roller
1 5 Write error in configuration memory (EEPROM)
of tester
9.5 Side slip tester ST 600
9.5.1 Warnings
Explanation
Error
Zero point invalid – toe sensor
1
9.5.2 Faults
Explanation
Error
Toe sensor cable break
1
Amplifier defective – toe sensor
2
|
1 691 706 020 2012-12-11
9.6 Chassis tester SA / SN 6xx
9.6.1 Warnings
Explanation
Error
Vehicle on chassis tester when switched on
1
Zero point too high – left scales sensor
2
Zero point too high – right scales sensor
3
Measured values invalid
4
No valid data available
5
No vehicle on chassis tester
6
Measured value buffer overflow
1 0
Power box temperature exceeded
1 1
Wait approx. 30 minutes before continuing with
measurement. Keep measurement cycles as short
as possible.
Filing error
1 5
With SN 680 additionally:
Explanation
Error
Temperature exceeded – left motor
1 2
Temperature exceeded – right motor
1 3
Communication problem with frequency converter.
5 0
Operation no longer possible.
Initialization error: No valid baud rate found. Operation
5 1
no longer possible.
!
To protect the motors of the chassis tester against
overheating, the software terminates operation of
the device as soon as the set running time (stan-
dard = 180 sec) is exceeded. Renewed switch-on is
possible. Always heed the information in the product
description.
!
Temperature monitoring SN 680 V2 (optional)
If equipped with temperature monitoring (tempera-
ture sensors at motors), the device can no longer be
switched on as of a motor temperature of 90 °C. The
motors must first be allowed to cool down to 60 °C.
9.6.2 Faults
Explanation
Error
Left scales sensor cable break
1
Right scales sensor cable break
2
Beissbarth GmbH