Motorcycle Test Routine - Beissbarth SL 6 Serie Manual Original

en 48 | SL 6xx | Manual mode (normal operation)
5.2.2

Motorcycle test routine

!
Heed the Motorcycle test procedure safety instructions given in the "User information" manual 1 691 696 920.
Risk of motorcycle tipping over due to lateral
drifting of the front wheel.
!
Use the motorcycle cover on the left side of the rollers. Use the standard cover (clipped in or hinged) on the
right side of the rollers.
i
The motorcycle test procedure can only be implemented in manual mode.
i
The weight is required for calculation of the braking factor. The weight can be entered or measured as follows:
$
Manual entry by way of remote control.
Manual weight entries have precedence over measured weight values.
$
Axle load weigher in brake tester (special accessory).
Use is automatically made of the measured weight if the weight has not been entered manually.
Step
1. Check prerequisites:
R
No motorcycle on brake tester
R
Test routine selected.
2. Drive onto the brake tester with
the wheel to be measured first and
keeping the motorcycle straight.
Disengage gear. Release brake pedal.
!
If the motorcycle is not straight on
the set of rollers, it will slide off
to the side. Counter-steer until the
motorcycle returns to straight position
on the set of rollers. Measurement is
not to be started before this has been
done.
i
It may be necessary to drive off the
set of rollers and then drive the
motorcycle back on.
|
1 691 706 020 2012-12-11
Remote control Result / Display
 Left: "Brake tester" device symbol.
 Right: Drive-on prompt.
 Wheel to be measured is positioned on set of
rollers.
 If axle load weigher is being used (special accessory):
The wheel load in kilogrammes appears on the
screen.
Beissbarth GmbH