Beissbarth SL 6 Serie Manual Original página 52

en 52 | SL 6xx | Manual mode (normal operation)
Step
4. Select measurement mode:
R
Axle measuring.
R
Left single wheel measurement.
R
Right single wheel measurement.
5. Shaker plate motor starts up.
i
For axle measuring, the left side is
measured first and then the right side.
6. Drive vehicle out of suspension tester.
|
1 691 706 020 2012-12-11
Remote control unit Result / Display
 Announcement phase:
 Message line flashes to indicate starting of
motor.
i
The measurement can be terminated at any
Axle measuring
time with the STOP button.
Left single wheel
Right single wheel
 Screen indicates active shaker plate.
 Vehicle is caused to oscillate.
 Motor stops after approx. 4 seconds.
 Measurement commences.
 Peak value display (approx. 5 seconds):
$
$
$
$
"
The measured values can now be stored. Refer
to Section 5.6.2.
"
Chassis measurement is over.
Road surface adhesion on left and right
side (↓).
Difference in road surface adhesion (Δ)
Resonant frequency on left and right side (f)
Difference in resonant frequency (∆f)
Beissbarth GmbH