BERTO'S 900 Serie Manual De Instrucciones página 67

Pressure in the cooking tank can reach a maximum value
of 0.05 bar.
When cooking is completed, switch the unit off.
Before opening the lid, discharge internal pressure
completely by activating the lever of the air valve (see
figure 8 "C").
Attention!
Do not leave the product in the tank at the end of cooking
with the lid hermetically closed for long periods. This
could damage the lid.
Switching off
Position the thermostat to position " " and the
commutator to position" ".
PART REPLACEMENT (SPARE PARTS)
Only qualified technicians can perform the operations
mentioned below!
Cut the power off from the unit (remove the fuses).
Replace the resistors
The resistors can be reached after disassembling the front
panel.
- disconnect the cables that power supply the resistor/s
- remove the resistor
- re-assemble the new resistor following the sequence in
reverse.
Replacing the lights
- Disconnect the power supply cables.
- Remove the lamp.
- Assemble the new lamp by following the sequence in
reverse.
WARRANTY CERTIFICATE
COMPANY NAME:
____________________________________________________________________________________________
ADDRESS:
____________________________________________________________________________________________________
POSTAL CODE :
__________
PROVINCE:
_______________
ATTENTION!
The manufacturer declines all responsibility for any inaccuracies in this handbook due to typing or printing errors.
The manufacturer reserves the right to make any changes that may be required without altering the basic features of the
product. The manufacturer declines all responsibility in the event that the instructions given in this handbook are not fully
observed. The manufacturer declines all responsibility for any direct or indirect damaged caused by incorrect installation,
tampering, poor maintenance and negligent use.
TOWN:
___________________________________________________________________________
INSTALLATION DATE:
____________________________________________________________
MODEL.
_________________________________________
PART NUMBER:
________________________________
Replacement of the operating thermostat or the safety
thermostat
The safety thermostat can be reached after disassembling
the front panel.
- After removing the front panel, disconnect the power
supply cables.
- Remove the bulb, located at the tank bottom, from the
front side.
- Remove the thermostat by unscrewing the support
fixing screws.
- Assemble the new thermostat by following the
sequence in reverse.
Replacement of the switch/selector
Remove the instrument board to reach the internal side.
- Disconnect the power cable.
- replace the switch/selector by unscrewing the blocking
screws to the support and after having pulled out the
operation coaxial thermostat.
- Assemble the new switch by following the sequence in
reverse.
| 67
EN