General Warnings; Appliance Description - BERTO'S 900 Serie Manual De Instrucciones

ATTENTION!
The figures mentioned in the chapters "GENERAL WARNINGS", "GAS MODEL INSTRUCTIONS" and "ELECTRIC
MODEL INSTRUCTIONS" are shown on the initial pages of this manual.
Before using the appliance, carefully read the instructions
provided in this booklet. The appliance is strictly for
professional use and must be used by qualified personnel.
The installation, start-up and maintenance of the appliance
must be carried out by qualified personnel. All installation
works must be carried out according to the law in force.
The manufacturer is not responsible for damages due to
an incorrect installation, bad maintenance or incorrect
use. This appliance cannot be used by people (including
children) with impaired skills or without experience
and knowledge unless under the supervision of a
person responsible for their safety who provides precise
instructions about the use of the unit.
Keep children under supervision to make sure that they
don't play with the unit.
LAW PROVISIONS, TECHNICAL REGULATIONS
AND DIRECTIVES
The manufacturer declares that the appliances comply
with the EEC directives and the particular reference
regulations. The manufacturer requires the installation to
be performed according to the regulations in force. Before
installing, check that the following provisions are met:
- building regulations and local fire prevention measures;
- accident prevention regulations in force;
- local Gas Board regulations;
- local electric energy supply Board regulations.

APPLIANCE DESCRIPTION

Sturdy steel structure with 4 feet that can be adjusted in
height.
External coating made in 18/10 chromium-nickel steel.
The serial number plate is located on the front of the
appliance and contains all the data necessary for the
connection.
PREPARATION
Before beginning the installation, remove the packaging.
A few parts are protected with an adhesive film, which
should be removed carefully.
Remove any glue residual with the proper substances,
such as petrol; never use abrasive substances. Mount the

GENERAL WARNINGS

unit feet; the unit must be levelled; small differences of
height can be solved by adjusting the feet.
The connections to the gas and/or electric network must
be close to the appliance and easy to reach.
We recommend placing the unit under a suction hood so
that vapour can quickly evacuate.
Install the unit at least 5 cm from the wall if the wall does
not bear a minimum temperature of 150 °C (see fig. 1). If
the unit is placed very closely to the wall, partition walls,
kitchen cabinets, decorative walls, etc., we recommend
that they are made with a non-combustible material with
a proper thermal insulation.
Pay a lot of attention to regulations concerning fire
prevention.
ATTENTION:
Air necessary for the burner combustion is equal to 2 cu
m/h per each kW of installed power.
Room ventilation
The room where the appliance is installed must be fitted
with air intakes to guarantee the correct operation of the
unit and air exchange.
Air necessary for the burner combustion is equal to 2 cu
m/h per each kW of installed power.
The air intakes must be of adequate dimensions, be
protected by grids and positioned free of any obstruction.
(See Fig. 2 – Fig. 3).
Attention!
For the Top versions, pay attention to the unit's distance
from the external border of the top.
Make sure that the bench or the cabinet you have chosen
can bear the unit.
Do not install the appliance close to other units that can
reach high temperature: the electrical components might
be damaged.
During installation, make sure the air suction and
evacuation ways are free from any obstacles.
In the event that a "FGP" gas oven is to be installed, the
floor must be made of heat and fire resistant materials.
| 55
EN