Upgrading Of The Ecoadd With A Bluetooth Interface - Ecolab EcoAdd Serie Instrucciones De Servicio

Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 750
13.2

Upgrading of the EcoAdd with a Bluetooth interface

To be able to monitor and control the pump using a suitable smartphone, you must fit a
Bluetooth PCB.
The pump can be ordered both with and without Bluetooth PCB. The Bluetooth
function can also be upgraded: See
DANGER!
Risk of electric shock
Pay attention to disconnect the power supply immediately and to secure
against accidental switch-on!
The following section explains how to fit the Bluetooth PCB.
Fig. 106: Upgrading with Bluetooth PCB
Order number for Bluetooth PCB: Article no.: 252080 (EBS no.: on request)
1.
Loosen the lid screws (4 x 1) using a Torx wrench (TX25).
2.
Remove the lid (2) by pulling it forward.
3.
Remove the connectors numbered 4-5, 6-8, 10-13 and 14-17 to create room to
install the Bluetooth PCB (4).
4.
Push the Bluetooth PCB (4) into the slot.
5.
Insert the connectors 4-5, 6-8, 10-13 and 14-17 again in the correct order.
6.
Check the front lid seal for contamination and clean as necessary.
7.
Place the front lid (2) on the housing in the correct position.
8.
Tighten the fastening screws.
NOTICE!
The tightening torque for the fastening screws on the control unit is
approx. 1 Nm. To prevent damage to the thread, we recommend
tightening the screws by hand.
Once the Bluetooth PCB has been installed correctly, the Bluetooth
symbol Fig. 106(9) appears in the bottom right of the display when you
switch on the pump.
Conversion, upgrade, repair
Ä Chapter 3.1 'Accessories' on page 28.
167
417102276 Rev. 3-01.2019
Tabla de contenido
loading

Tabla de contenido