Electrical Installation - Ecolab EcoAdd Serie Instrucciones De Servicio

Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 750
Assembly and installation
6.4

Electrical installation

Personnel:
DANGER!
Risk of electric shock
Pay attention to disconnect the power supply immediately and to secure
against accidental switch-on!
Fig. 16: Electrical Installation of 'EcoAdd'
1.
Remove all four housing screws.
2.
Remove the front cover.
3.
To connect additional external enable signals, route the connector lines through the
clamping cube.
4.
Performing the electrical installation
Ä Chapter 6.4 'Electrical installation' on page 50.
5.
After electrical installation has been completed, fit the cover back onto the housing.
6.
417102276 Rev. 3-01.2019
n
Qualified electrician
The mains cable is already installed at the factory.
Permissible external cable diameters for connecting the inputs/outputs:
AD Ø = 5.1-5.7 mm. LIYY 4 x 0.5; LIYY 5 x 0.34; LYCY 2 x 0.34
Permissible cables: Ölflex 4 x 0.5
The IP65 is applicable only when the specified cable is being used.
NOTICE!
Make sure that the seal is free of dirt to ensure that it seals the system
properly.
NOTICE!
Tighten all four housing screws (pos. 1) "by hand".
50
Tabla de contenido
loading

Tabla de contenido