2
Security
2.1
General Safety
DANGER!
If you assume that safe operation is no longer possible the pump must be put
out of service immediately and be secured against unauthorized use.
This is the case if:
– is visibly damaged
– appears no longer functional
– prolonged storage under unfavorable circumstances has occurred
(carry out function check).
The following notes should be observed:
– Before any work on the electrical section, disconnect power and secure
against being switched on again .
– The safety provisions for handling chemicals must always be observed and,
if applicable, suitable protective clothing must be worn
– Notes in the product data sheet of the used dosing medium has allways to
be observed.
– The installation may only used with the specified supply and control voltage
in the technical data.
2.2
Intended use
WARNING!
Proper use particularly includes the following points:
– Only liquid, validated chemicals may be metered.
– Depending on the material used, the metering system is designed for acidic
and alkaline products.
– The temperature range, the permissible ambient temperature and the
maximum media temperature is permissible only as described in the
"Technical data".
– The metering capacity is between 5 and 120 l/h depending on viscosity and
back-pressure.
– The back-pressure must not exceed 1 MPa (10 bar), according to DIN EN
809.
– The operating voltage has to be produced only as described in the
"Technical data".
– The ambient temperature must be between +5 and +45 °C.
– The pump has been developed, designed and built for industrial and
commercial use. Private use is excluded!
Any use which extends beyond or differs from the proper use is considered
improper use.
Proper use also includes compliance with all operating instructions prescribed by the
manufacturer, as well as with all maintenance and servicing conditions.
15
Security
417102276 Rev. 3-01.2019