Operating Mode] [Pulse] - Quantity - Ecolab EcoAdd Serie Instrucciones De Servicio

Control / software

7.9.3.2 [Operating mode] [Pulse] - Quantity

Fig. 40: Operating mode: Pulse
1. [Open Main menu] :
2. [Operating mode] - [Pulse] selection.
3. [Press Next button]
ð Screen change for setting: 'Pulse interval' .
4. DO NOT enter a pulse interval, or set pulse interval to 0!
To do this, set the decimal places to 0 using the scrollbar.
Then select the field for entering the decimal point and also set the decimal point to 0
using the scrollbar.
5. [ Press Next button]
ð The screen changes to the 'Pulse memory' prompt.
6. Select whether the 'pulse memory' is to be used.
ð If you select the 'Pulse memory' , a
7.
Press the
ð Settings are saved, and the screen returns to the overview of the
[Operating mode] .
8. Press the
ð The screen switches back to the overview of the [Main menu] .
9.
Press the
ð The screen switches back to the [operating display] .
10. Keep the displayed value (l/pulse) for the rate pressed down for approx. 3 seconds.
ð The configuration page for converting the unit (l/pulse) is displayed.
11. Tap the required unit (l/pulse, ml/pulse, G/pulse) of the concentration setting and
select the required unit.
12. Press the
ð The screen switches back to the concentration setting.
13. If necessary, adjust the concentration value with the newly set unit.
14. Press the
ð The screen switches back to the [operating display] .
417102276 Rev. 3-01.2019
Ä Chapter 7.7 'Main menu' on page 67
.
.
button.
button.
button.
button.
button.
80
appears in the selection box.