Ecolab EcoAdd Serie Instrucciones De Servicio página 281

Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 750
Fig. 51: Configuration: Access code
Factory setting: No access code
[Set Access code] :
1.
[Call up Main menu] :
2.
[Select Configuration] :
3.
[Access code] .
ð Screen change: 'Access code' 'Administrator (A)'
4.
[Access code] enter with the scrollbar.
5.
[Press the Next]
ð Screen change: 'Access code' 'Operator (O)'
6.
[Access code] enter with the scrollbar.
7.
Pressing the
button saves the setting.
ð The screen switches to the overview: [Configuration].
8.
By pressing the
9.
By pressing the
If the [Access code] has been entered to be able to make settings on the
pump, a clock symbol is shown on the operating display (pos. 1). It runs
backwards for 15 minutes and then blocks the pump again automatically.
Within this time, if you switch back to Menu, then this period starts all over.
The pump can be immediately stopped by "tapping" on the "clock symbol",
without the clock ticking any further.
If only the [Access code] of the Administrator (A) is set, no code letter is
displayed in the clock symbol. If both access codes are set, the code letter
belonging to the current login (Administrator (A) or Operator (O)) will always
appear.
Ä Chapter 7.7 'Main menu' on page 67
Ä Chapter 7.10 'Overview - Configuration' on page 87
button.
button, you can return to the [Main menu].
button, you can return to the [operating display].
If an [Access code] has been set, this is visible on
the display while the pump is in operation.
The activated [Access code] is indicated by a closed
padlock symbol
93
Control / software
on the operating display (pos. 2).
417102276 Rev. 3-01.2019
Tabla de contenido
loading

Tabla de contenido