Bard ENCOR ENSPIRE Instrucciones De Uso página 5

3. Turn on the main power via the power
switch on the rear of the console as
illustrated in Figure 12.
Figure 12 – Main power switch
5. If desired, connect the appropriate driver to the rectangular connector on the rear of
the console illustrated in Figure 14. The active driver is connected by a green LED
light above the connector. Reference the applicable driver Instructions for Use for
further information of driver setup. If desired, connect the appropriate foot pedal to
the connector on the rear of the console as illustrated in Figure 14.
6. Follow the touch screen prompts. Install and calibrate the biopsy probe.
Reference the applicable probe Instructions for Use for further information
on probe setup.
Operating the system via the touch screen
7. Complete the biopsy procedure per the "Directions for Use" section of the
Instructions for Use packaged with the driver being used.
8. The E C E Breast Biopsy System status is displayed on the touch screen
N OR NSPIRE ™
(Figure 15). The sample acquisition options may be selected via this screen.
the circle on the touch screen as illustrated in Figure 15.
b. To change the sampling from full to half, touch the "half sample" button as
illustrated in Figure 15.
Touch the "full sample" button to return to full sampling.
c. To change the sample mode from normal tissue to dense tissue, touch the
"dense tissue" button as illustrated in Figure 15. Touch the "normal tissue
button" to return to normal tissue sampling.
Half Sample button Full Sample button
9. During the procedure, the E
rinse mode when using the vacuum and rinse tubing cassette and saline. This mode
allows the operator to apply a saline rinse to samples collected in the sample trap.
Initiate the rinse by pressing the "rinse" button on the touch screen.
10. If needed, the E C E
N OR NSPIRE
administer additional anesthesia through the E
Anesthetic Mode, touch the "Anesthetic Mode" tab as illustrated in Figures 15 and
16. Select the desired anesthetic option to sweep the sample notch through the
desired pattern while administering anesthesia. Leave Anesthetic Mode by pressing
the "sample" button on either the handswitch or footswitch.
11. Following the procedure, the E
operator to deploy a marker through the probe. Enter Marker Mode by pressing
the "Marker Mode" tab on the touch screen as illustrated in Figure 17. Deploy
the marker per the marker Instructions for Use. Rotate the sample notch 180° by
pressing the "180°" button on the touch screen as illustrated in Figure 17
Marker Mode by pressing the "sample" button on either the handswitch or footswitch.
Dense Tissue button
C E Breast Biopsy System has an optional
N OR NSPIRE TM
Rinse button
Breast Biopsy System allows the operator to
TM
C Biopsy probe. To enter
®
N OR
Anesthetic Mode tab
C E Breast Biopsy System allows the
N OR NSPIRE TM
4. Turn on the standby power via the
switch on the front of the system as
illustrated in Figure 13.
Normal Tissue button
3
Figure 13 – Standby power switch
Figure 14 – Driver and foot pedal connectors
Figure 15 – The touch screen – Main Screen
Figure 16 – The touch screen – Anesthetic Mode