PASO 16
New Swivel assembly (part 2)
Orient the Swivel assembly as seen in the picture.
There is a tiny magnet in the Idler nut FS part. Make sure it is in place.
In case the magnet has fallen out, there is a replacement one in the package.
Slide the Swivel B part onto the screws.
Attach the M3nN nuts onto the screws. Tighten the screws gently while holding the
nuts using the neeedle-nose pliers.
Do not overtighten the nuts. The Swivel must be able to move freely.
PASO 17
Tension screws parts preparation
Para los siguientes pasos, por favor prepara:
M3x30 screws with the springs (2x) you have removed earlier
We will need the springs alone. The old M3x30 screws won't be re-used.
Remove the springs from the old M3x30 screws.
M3x35 screws (2x) the new, slightly longer ones.
This screw is a new type not previously used on a printer! Do not reuse old
screws, as they are a different size and would not fit properly!
Screw guide (1x)
98
9A. MK4 Nextruder mod
Ensamblaje Original Prusa MMU3
