PASO 9
Preparación de las piezas de las poleas del motor
PASO 10
Pulley assembly
Orient the motor as seen in the pictures. Make sure the motor cable is facing to the
back.
Rotate the motor shaft so that the flat part is facing up.
Slide the first pulley onto the shaft. Ensure the lock screw is on top (facing the flat
part of the shaft). Tighten the grub screw just slightly.
The first pulley should be around 30 mm (1.18 inches) from the motor. Don't tighten
the grub screw fully yet!
Ensure the grooved part of the pulley is on the motor side.
Slide the other pulleys onto the shaft using the same technique. Tighten the grub
screws just slightly for now.
52
6. Montaje del cuerpo de polea
Ensamblaje Original Prusa MMU3
Para los siguientes pasos, por
favor prepara:
Motor de la polea (1x)
Pulley (5x)
In case you're upgrading from
the MMU2S, the pulleys might
be already attached to the
motor.
Tuerca M3nS (1x)
Tornillo M3x10 (3x)
