PASO 14
New Swivel parts preparation
PASO 15
New Swivel assembly (part 1)
Take the Swivel A part and orient it as seen in the picture.
Insert the M3x22 screw into the opening near the thick part of the Swivel A.
Slide the spacer onto the screw.
Insert the second M3x22 screw into the other opening on the side.
Slide the Idler nut FS part onto the M3x22 screw.
9A. MK4 Nextruder mod
Ensamblaje Original Prusa MMU3
Para los siguientes pasos, por
favor prepara:
Idler nut FS (1x) with the 3x1mm
magnet installed
Swivel B (1x) the new part
Swivel A (1x) the new part
M3nN nut (2x) you removed earlier
Spacer 6x3.1x8 (1x) you removed
earlier
M3x22 screw (2x)
This screw is a new type not
previously used on a printer! Do
not reuse old screws, as they
are a different size and would
not fit properly!
97
