PASO 5
MK3.5 Cable installation
Take the Ext-cable-holder-a plastic component. There is a small part that needs to
be breaked off in order to make space for the MMU cable. Remove the part using
needle-nose pliers.
Similarly, remove the break-off part on the Ext-cable-holder-b.
Loosen the two M3x10 screws on top of the cable cover.
Guide the MMU/Printer cable through the corresponding opening into the xBuddy
box.
PASO 6
MK3.5 Cable management
Plug the MMU/Printer cable into the corresponding connector on top of the
xBuddy board.
Attach the cable-holder-b back onto the xBuddy box using two M3x10 screws.
Insert two new zip-ties into the marked opening on the inside of the xBuddy box.
Make sure the zip-ties wrap around the cable bundle.
Attach the cable-holder-a part using two M3x18 screws. Make sure no cable is
getting pinched.
To verify the remaining cable connections are connected properly, refer to the
MK3.5 assembly guide
184
10C. MK3.5 Setup and Calibration
Ensamblaje Original Prusa MMU3
