PASO 3
Attaching the MMU unit (part 2)
Make sure the unit is in the middle of the frame. Once we engage the clamps, it
won't move left and right as easily anymore.
Press the back part of the MMU3 unit downwards slightly, until the clamps lock to
the frame.
Check that both bottom clamps on the unit are fully engaged.
If you need to remove the unit from the frame, simply lift the back part up to
disengage the clamps.
PASO 4
Attaching the cable bundle
Let's move onto the electronics box side of the extruder cable bundle.
Tighten up the sleeve around the cable bundle. Hold it tight before you fix it in
place with the clip and the screws. The textile sleeve should be held by the cable
clip
Fix the cable bundle in place by tightening the two M3x10 screws holding the
Extruder-cable-clip. Make sure no cable is getting pinched!
For easier cable-management inside the electronics box, attach the extruder cable
bundle to the hooks on the inside of the Einsy-base with two zip-ties in the marked
positions.
160
10B. Configuración y Calibración MK3S+
Ensamblaje Original Prusa MMU3
