10A. Configuración y Calibración MK4
PASO 17
SuperFINDA sensor calibration info
Good! After calibrating the filament sensor in the extruder, we can move on to
calibrating the SuperFINDA sensor inside the selector on the MMU unit.
In the next step, we will adjust the sensor's position and check if it detects the
filament correctly.
It is EXTREMELY important that both the filament sensor inside the extruder and
the SuperFINDA sensor work reliably and provide accurate readings. Otherwise,
you will have trouble with the device.
There is an inspection window on the side of the selector where you can observe
the SuperFINDA's position. It is a good starting point to line up the bottom of the
SuperFINDA probe with the top of the inspection window when looking from the
selector motor side.
If there is a filament in the selector, the steel ball is risen and should be detected by
the SuperFINDA sensor. The distance between the ball and the sensor is what must
be perfectly calibrated.
Ensamblaje Original Prusa MMU3
151
