PASO 18
Encendido y reinicio de la MMU MK3S+
After finishing the firmware update, make sure there are no filaments loaded
neither in the extruder, or in the MMU unit.
Navigate to the LCD menu > Settings > MMU
and make sure it is set to MMU [On]
Pulsa el botón de reinicio en la caja LCD de la impresora.
From now on, the reset button on the printer resets also the MMU unit. Wait for a
while, the MMU unit will go through the self-test routine. (accompanied by flashing
LED lights on the MMU unit) Wait until it boots up properly, before issuing any
commands to the printer.
In case of necessity, the reset button is also useful to help you get out of some
unrecoverable situations even for the MMU unit. But remember, it also aborts an
ongoing print immediately.
If you see the
detecting a filament.
PASO 19
MMU3 Firmware flashing (part 1)
The MMU3 firmware file needs to be flashed into the MMU unit itself. Find the
microUSB connector on the right side of the MMU3 unit.
Connect the unit to your computer using the bundled microUSB cable.
On your computer, select the appropriate MMU firmware file compatible with your
printer model.
170
10B. Configuración y Calibración MK3S+
Unload manually error, check that the SuperFINDA sensor is not
Ensamblaje Original Prusa MMU3
