PASO 3
Aflojar el conjunto de cables MK3S+
In order to use MMU3 on your MK3S+, a few components on the print head need to
be changed. First, we need to release the extruder cable bundle.
If you use MK3.5 printer, skip two steps ahead.
Using an Allen key release the M3x40 screw on the electronics box and open the
door on the other side.
Release two M3x10 screws and remove the extruder-cable-clip on top.
In case there are zip ties holding the cables inside the electronics box, carefully cut
and remove them.
PASO 4
Desconectando el cable del sensor infrarrojo de filamento MK3S+
Carefully unplug the IR filament sensor cable and make sure it is free inside the
electronics box.
We need to gently pull the IR filament sensor cable slightly towards the extruder
as the sensor will be in a different position. Make sure the entire path of the cable
is free. However there is no need for a complete disassembly.
9B. Mod extrusor MK3S+ / MK3.5 (KIT)
Ensamblaje Original Prusa MMU3
107
