Original Prusa MMU3 Manual Del Usuario página 196

Ocultar thumbs Ver también para MMU3:
PASO 23
MMU-to-Extruder PTFE tube parts preparation
Para los siguientes pasos, por favor prepara:
Tubo PTFE 360x2.5mm (1x)
The new PTFE tube has an internal diameter of 2.5mm. In case you are
upgrading from the 2mm ID MMU2S tube, and you have trouble distinguishing
between the old and the new one, try comparing the internal diameter of the
two. See the second picture. The tube on the left is the new one.
A 2.5mm ID PTFE tube is required for the MMU3.
FESTO fittings (2x)
PASO 24
MMU-to-Extruder PTFE tube
Attach the Festo fittings onto both sides of the new PTFE tube (4x2.5x360mm)
Push the PTFE tube in fully.
Consejo rápido: Si necesita retirar el tubo de PTFE del racor, presiona la pinza
azul hacia dentro. Mientras la pinza está presionada, presiona primero el tubo
de PTFE hacia dentro y, a continuación, extráelo por completo.
Attach the PTFE tube onto the printer. One end goes onto the selector. The other
goes onto the extruder. Tighten the fittings up using the Unikey.
196
10C. MK3.5 Setup and Calibration
Ensamblaje Original Prusa MMU3
loading

Productos relacionados para Original Prusa MMU3