PASO 5
MK3.5 Releasing the cable bundle
This step is valid for MK3.5 printer only. If you are using the MK3S+, skip to the
next one.
Remove four M3x6 screws holding the xBuddy cover. Remove the cover.
Remove the two M3x18 screws holding the front part of the cable holder and
remove the Ext-cable-holder-a part.
Carefully cut and remove the zip ties securing the cable bundle, taking care not to
damage any cables.
We need to gently pull the IR filament sensor cable slightly towards the extruder
as the sensor will be in a different position. Make sure the entire path of the cable
is free. However there is no need for a complete disassembly.
PASO 6
X-carriage-back disassembly
Cut and remove all the zip ties on the cable holder behind the extruder.
Release the textile sleeve on the cable bundle by pulling it back slightly. Usually,
there is no need to remove it completely.
Remove all four M3x10 screws on the X-carriage-back part.
Split the x-carriage about 10 mm (0.4 inch) apart in the back to ensure the cables
will be able move through more easily.
108
9B. Mod extrusor MK3S+ / MK3.5 (KIT)
Ensamblaje Original Prusa MMU3
