PASO 9
IR Filament sensor cable
Find the IR filament sensor cable inside the cable bundle and move it from the
electronics box towards the extruder slightly.
Grab the wires of the IR filament sensor cable and try gently pulling it up to the top
of the extruder.
Don't pull hard on the cable.
Push the cable towards the extruder from the electronics box, while you are
pulling the cable on top. This way, the cable should slide without a significant
resistance.
Combine gentle pushing and pulling on the cable to avoid damage.
We aim to get 6cm (2.4in) of the cable above the top of the extruder body.
110
9B. Mod extrusor MK3S+ / MK3.5 (KIT)
Ensamblaje Original Prusa MMU3
