PASO 8
Idler disassembly
We will need to take the Idler assembly apart.
Remove the M3x6 screw.
Split the printed parts to open it up.
Set aside for later use: Bearings, pins, spacer and the screw.
The printed parts won't be re-used. Set them aside so that they don't mix up with
the new parts.
PASO 9
New Idler parts preparation
94
9A. MK4 Nextruder mod
Ensamblaje Original Prusa MMU3
Para los siguientes pasos, por
favor prepara:
Idler-lever-a (1x) the new part
Idler-lever-b (1x) the new part
The older Idler printed parts,
made from PETG, are prone to
bending over time. Do not reuse
these old parts, as they may
cause the printer to
malfunction.
Bearing 693 2RS (2x) you removed
earlier
Pin 2.9x8.5 (2x) you removed earlier
M3x6 screw (1x) you removed earlier
Spacer tube 13.2x3.8x0.35 (1x) you
removed earlier
