PASO 1
Preparation
PASO 2
Disconnecting the PTFE tubes
28
3. Desmontaje Buffer MMU2S (UPG)
Ensamblaje Original Prusa MMU3
In case you have the old version of
the buffer in the assembled state, it
is necessary to disassemble it first.
We will re-use only the six large
plastic plates from it.
If you have the plastic sheets alone,
please skip to the next chapter.
Remove the five M3x10 screws
holding the PTFE tubes in the
buffer.
Pull all the PTFE tubes out.
Desecha los tubos para evitar que
se mezclen con los nuevos en el
futuro. Estos tubos no se volverán
a utilizar.
